Spoon carving

A spoon is a simple project, but very satisfying. Hardwoods are the preference, and willow, holly, plum, alder, apple, elm, ash, sycamore, hawthorn, cherry or birch will all work well.

• Choose stock well, use the shape of the crook, bend, limb, for your desired design. It is much easier to work green, though it is good practice to allow to dry after main body of work is done, prior to final shaping. This allows for correction on any distortion the drying produces.
• Split your blanks off with a froe.
• Transfer your design to stock.
• Rough out with hatchet, side axe or similar tool.

• Leave bowl outside large, then gouge out bowl.

• Shape outside bowl carefully, use fingers to feel thickness, rough shape handle.
• Put aside to dry.
• Final finish, trim lip of bowl, any other decorative touches.
• Scrape, sand to finish add coat of oil.

Jewelry box lid

• Plane and square stock for frame.
• Router , plunge cut slot for floating lid panel.
• Cut mitres and glue up, can use splines, biscuits, dovetail key splines for strength.
• DO NOT GLUE PANEL, as with base movement gaps needed.
• Final sand, add hardware.
• Oil to finish.

Jewelry box inner carcass and bottom

• Cut mitred inner carcass and fit; same wood, iroko, but lighter.
• Scribe in bottom panel, with expansion gap 1mm, and skew pin in position.

• Coat of oil to finish.

Next, constructing the lid...

Jewelry box; design and outer shell...

This project is going to be a more complicated one, encompassing a few disciplines, fretwork, tiny dovetails, and chip carving. I hope it will make me more precise, and patient!...

• Design to be drawn out full size.

• Stock to be plane and squared up.
• Transfer fret work design to stock, I just photo copied and glued it on.
• Drill entry holes for saw blade, and cut. I used a hand saw. Be sure to clamp up to provide support to delicate sections, and work out which cuts to do 1st, in order to decrease chance of damage. I recommend delicate outer sections 1st.

• Clean off paper with a scraper, then sand. Small file to finish shaping.
• When all sections are finished, cut dovetails (for how to see my first post from last year), and glue up and assemble. Take care as pins are only 4mm at largest point!

To be continued...

Toy boat

Today I made a simple toy boat;

• Design and then draw a rod.

• Mark out, then cut your stock, working through the facets.

• Shape the bow with a spokeshave. Then fair in the hull.

• Cut and fit coach house roof to deck as per rod.

• Drill and fit mast.

• Cut and fit sail, final sand, and oil.

To see how to build a small dinghy, see my other blog site www.studentboatbuilder173316.blogspot.com

Toy tractor

Today I made another toy, this time a tractor. Here's how I did it;

• Draw a design, then a rod to work from.

• Mark out, and then cut components.

• Sand, and assemble.

• Give a final sand, and a coat of oil....

• Trailer to follow.....